Stress-Strain Behaviour of Completely Decomposed Granite in Both Triaxial and Plane Strain Conditions
Abstract
Most of the field problems in geotechnical engineering are in three dimensional state or close to a plane strain condition. Strength and deformation properties of soils in plane strain condition are considerably different from those in an axisymmetric condition. Many researchers have investigated the behaviour of soils under a
plane strain condition. However, most of the previous studies have concentrated on sedimentary type of soils like sand and clay. Our understanding on the plane strain behaviour for residual soils is less than that for sedimentary soils. A true triaxial system with four sliding rigid-plates and real time feedback control has been
used to test specimens of a completely decomposed granite (CDG) soil (a residual soil) under plane strain condition. The setup of the true-triaxial rigid plates is briefly introduced first. The preparation of soil specimens and testing procedures are described. The basic properties of the CDG are presented. The stressstrain
and strength behaviour of the soil obtained under plane strain condition was investigated and compared to the behaviour obtained under axisymmetric loading conditions. The results revealed that the critical state line in q-p′ space obtained under plane strain condition is the same as that obtained under axisymmetric
condition. However, the critical state line in e- ln p′ space obtained under undrained plane strain condition is different from that obtained under axisymmetric condition. The peak friction angle for plane strain tests is higher than that from axisymmetric loadings. It is also found that shear bands occur only in drained plane strain compression. Defuse bulging is the mode of failure for undrained plane strain as well as triaxial loading.
plane strain condition. However, most of the previous studies have concentrated on sedimentary type of soils like sand and clay. Our understanding on the plane strain behaviour for residual soils is less than that for sedimentary soils. A true triaxial system with four sliding rigid-plates and real time feedback control has been
used to test specimens of a completely decomposed granite (CDG) soil (a residual soil) under plane strain condition. The setup of the true-triaxial rigid plates is briefly introduced first. The preparation of soil specimens and testing procedures are described. The basic properties of the CDG are presented. The stressstrain
and strength behaviour of the soil obtained under plane strain condition was investigated and compared to the behaviour obtained under axisymmetric loading conditions. The results revealed that the critical state line in q-p′ space obtained under plane strain condition is the same as that obtained under axisymmetric
condition. However, the critical state line in e- ln p′ space obtained under undrained plane strain condition is different from that obtained under axisymmetric condition. The peak friction angle for plane strain tests is higher than that from axisymmetric loadings. It is also found that shear bands occur only in drained plane strain compression. Defuse bulging is the mode of failure for undrained plane strain as well as triaxial loading.
To list your conference here. Please contact the administrator of this platform.
ISSN: 1993-0461 ISSN: 2225-157X,
Edited and Published by Jordan University of Science and Technology, P.O.Box 3030, Irbid 22110, Jordan
Mailing address: Prof. Fouad Gharaybeh, Ph.D.
Editor-in-Chief Civil Engineering Department Jordan University of Science and Technology Irbid 22110, Jordan Tel. No. + 962 2 7201000 ext. 22104 Fax No. + 962 2 7201073
Submission & Subscriptions E-mail:jjce@just.edu.jo