Design and Manufacture of Plank Shoot – Back Containment Structure
Abstract
When the causes and effects of the plank shoot – back phenomenon were established, the need for a safety device was also established. A plank shoot – back containment structure has therefore been designed, manufactured and tested. The results of the test have shown that the structure can trap about one hundred percent (100%) of plank pieces that shoot out from the saw blade before they can harm operators or by standers. Table saw operators have accepted the structure as a good safety device they can use with their saw mills.
Keywords: Plank, Shoot –Back, Containment, Structure.
To list your conference here. Please contact the administrator of this platform.
Paper submission email: ISDE@iiste.org
ISSN (Paper)2222-1727 ISSN (Online)2222-2871
1Please add our address "contact@iiste.org" into your email contact list.
This journal follows ISO 9001 management standard and licensed under a Creative Commons Attribution 3.0 License.
Copyright © www.iiste.org