Effect of Welding on Lateral-Torsional Buckling Resistance of I-Shaped Built-up Steel
Abstract
An experimental investigation was made of the inelastic lateral-torsional buckling of built-up steel I-beams. All beams were carefully fabricated with controlled levels of initial crookedness. Nineteen beams were tested in five groups under same loading conditions with two points load applied at the top flange. The results confirmed that built-up beams of intermediate slenderness with fillet welds on one side of the web are sometimes stronger than their counterpart beams with fillet welds on both sides of the web. It was found that design loads predicted by the Australian Standard provided good lower bounds estimates to failure loads of the tested beams.
To list your conference here. Please contact the administrator of this platform.
ISSN: 1993-0461 ISSN: 2225-157X,
Edited and Published by Jordan University of Science and Technology, P.O.Box 3030, Irbid 22110, Jordan
Mailing address: Prof. Fouad Gharaybeh, Ph.D.
Editor-in-Chief Civil Engineering Department Jordan University of Science and Technology Irbid 22110, Jordan Tel. No. + 962 2 7201000 ext. 22104 Fax No. + 962 2 7201073
Submission & Subscriptions E-mail:jjce@just.edu.jo